Freelander Rear Window Calibration Procedure

Press the power rear window control switch vent button six times.

Freelander rear window calibration procedure. Press and hold the window switch all the way down for approximately 17 seconds. The window lift ECU maintains these connections until the door window motor stalls after driving the window fully down or an up selection is made on the window switch. Make sure window is in the full open position. You might have to hold it there with your finger.

Then manually raise the window actually just hold the button up as the window cant raise further for 2-3 secs. To reset the memory settings for your window press the button for each window down and hold it for 2-5 seconds. The automatic window function relies on a sensor and electrical components to interpret when a window is open or closed so replacing your cars electrical power source can mess with these settings. If the latch is not pused in fully the window wont roll up.

On 5 door models each rear window switch on the centre console is connected to the window motor via the related rear door mounted window switch. Lower the window all the way manually. If the calibration procedure is unsuccessful the CCU will sound a warning for approximately 08 seconds and fully lower the window. Good afternoon fellas 2005 Freelander replaced battery rear window goes down.

This calibration is needed after your w. Switch off the ignition. This video shows you how to cheaply 8 fix the rear tailgate window on the Landrover freelander 1 by installing new cables. Iii Fully close the tail door window.

Press the power rear window control switch vent button six times. Can I confirm that this is the calibration procedure that youve tried. Iv If the tail door window remains closed the calibration procedure is complete. Check whether the reset procedure was successful.

How to relearn your BMW windows end positions for all the safety and comfort features to work properly in your car. Model - Freelander Affected Range - All derivatives Re-Issue Information Problem - TAIL DOOR GLASS OPENS AUTOMATICALLY IMMEDIATELY AFTER CLOSING Cause Tail door glass calibration incorrectly set within the Central Control Unit CCU. Window will move up through its full travel then down and back up again. This is so it knows where the window is for opening the tail gate.

7 If the calibration procedure is unsuccessful the CCU will sound a warning for approximately 08 second and fully lower the window. Performed calibration procedure right out of Land Rover GTR numerous times. After battery connection the Freelander is calibrating the rear window position when yer putting the tail gate window up. This problem started when I left the lights on and battery went dead.

I put the key in the outside of the door and turned to the right and the window will roll up and stay there. If it dont see it as up then for safety it defaults to down. My Freelander -2004. Repeat the calibration procedure from step 1.

Turn the ignition to the ON position. Tail Door Window Open Warning If the tail door window is calibrated and open and on 3 door models the roof is closedon and a lock request is made from the remote handset or the drivers door key barrel the CCU will sound an audible miss-lock. The window goes up fine but when it closes all the way up comes right back down. Then manually raise the window for about 2-3 secs and stop.

Action Where a complaint of the above is confirmed follow the calibration procedure below to reset the tail. It also shows an improvement f. On fitment I followed the rear window calibration procedure in the haynes manual and from other forum sources. Posted to European Electrical on 1222009 5 Replies.

Ii Fully open the tail door window. Tailgate window wont come up. Operating the back door handle the window drops to clear the recess allowing the door to be opened correctly. The power rear window will move up-down-up-down approximately 20 mm 08 in.

Hellonot thinking i went to open my freelander rear door when frozen the glass won t drop to open will this be expensive to repair. Everything worked rear window ok until early this year Jan 2012 when I had to replace the main battery. Turn the ignition to the OFF position. The calibration procedure will need to be performed to restore normal tail door window operation.

My window was working normally after that. With the ignition on use the console switch or the vehicle key in the tail door lock to raise the window until the motor stalls with the window fully closed. Push the lock button on the remote until the doors lock. Disconnect the battery earth lead.

Lift the switch and hold up. Window goes up with switch then immediately goes back down.

If you are searching for Freelander Rear Window Calibration Procedure you've arrived at the ideal location. We have 15 images about freelander rear window calibration procedure adding images, pictures, photos, wallpapers, and much more. In these webpage, we also have variety of graphics available. Such as png, jpg, animated gifs, pic art, symbol, blackandwhite, transparent, etc